Engineered wood flooring - Installation at a glance
1. Unroll the underlay and put it on the prepared subfloor. |
2. Center and align the planking area and cut the first row to size. |
3. Use the spacer wedges to guarantee the wall spacing of at least 10 to 15mm towards all walls and structural parts within the room. |
||
4. The last board of the first row is cut to the right size - don't forget to include the wall spacing. The cut-off piece is used as the starting piece for the second row. |
5. Start your next row from the left hand side like before. Simply click together the planks' longitudinal sides. The use of glue is not required here. |
6. Join the short end sides together using a hammer and the hammering protection device. During this process the longitudinal and short end joints will interlock automatically. Continue to install the rest of the room in this manner. |
||
7. Use a cut-off piece to transfer the profile of the wall to the last row of planks. |
8. Cover the gaps all around the flooring area with matching skirtings from Parador's wide selection. |
9. You are done! |
||
10. *Industrial Design Flooring requires full-surface glue down installation. |
||||
Prior to installation please refer to and obey the rules of installation that are stated on the following pages. Paying attention to these rules and advice is a prerequisite to the success of your installation and also guarantees that your engineered wood flooring will be a long-term asset.